A complete discounted set of door pull, handle and security rosette for entrance doors. When ordering, it is necessary to define the type of material in which the door pull will be mounted and also the door opening.
Pull handle H1
Traditional elegant door pull in AISI 304 stainless steel. This is the best-selling door pull, the quality of which has been tested by several thousand of our customers. The door pull is designed for mounting in the sash of the entry door - not in the door infill panel.
The door pull can be mounted to plastic or aluminium entry doors. The spacing of the door pull legs is designed so that the door pull does not bend. The door pull rod is supplied as standard in a diameter of 30 mm with a wall thickness of 1.5 mm. A door pull using
a rod with a diameter of 40 mm is used for longer dimensions. For extreme oversize applications, it is possible to use a rod with a thickness of 50 mm. Door pulls are available in lengths of up to 3,500 mm.
We keep these door pulls in stock for immediate delivery.
We are also able to provide you with a custom length door pull as well. Please note that a lead time of 4 to 6 weekswill be required.
One-sided handle with rounded rosette under the handle and rosette for the lock cylinder.
The rosette for the lock cylinder is attached with two screws .The square is inserted into the lock and then tightened with a nut. In this case, the square acts as an anchoring element to which the handle is attached.
This method of attachment is suitable for door pull / handle combinations.
We do not recommend using door handles with door pulls that are not rated for single-sided mounting.
Exterior rosette PZ 60 is supplied in stainless steel as standard. The rosette covers the lock cylinder. It is suitable for common lock cylinders, which protrude to the exterior in the range of 6-7 mm. The rosette is 11.5 mm tall.
When mounting, it is necessary to pre-drill a hole with a diameter of 3 mm and a spacing of 50 mm. The rosette slides in and locks when the lock cylinder is inserted. Therefore, the rosette cannot be removed without removing the lock cylinder.
Exterior rosette PZ 58 is supplied in stainless steel as standard. The rosette is does not cover the lock cylinder. It is suitable for common lock cylinders. The rosette is 6 mm tall. The lock cylinder should therefore not protrude more than 6 mm.
When mounting, it is necessary to pre-drill a hole with a diameter of 3 mm and a spacing of 50 mm. The rosette slides in and locks when the lock cylinder is inserted. The rosette cannot be removed without removing the lock cylinder (if the lock cylinder protrudes a minimum of 4 mm).